The rear point is the Z-offset which you set via the menu and the two points in front are set via the knobs. The leveling is also supported via the menu. The leveling of the print bed is carried out at three points with the knobs on the underside of the print plate. This way there are no twists in the filament and it can’t get tangled anywhere. The filament holder is placed so that the filament from a standard roll can be inserted directly into the extruder. You don’t have to tighten any screws or anything else, gravity holds it in place. It is hung on the back of the 3D printer in the rear wall. Mounting the filament holder is similarly simple. The fact that you can remove the glass bed so easily gives you the possibility to remove your finished prints more easily and to clean the print bed comfortably. The assembly is very easy because it only has to be pushed onto the printing plate and tightened with the two levers. The glass bed is included separately and must be mounted before your first test prints. You only have to mount the glass bed and the filament holder, level the print bed and load the filament. The setup of the Voxelab Aries is comparatively easy, as it is already almost completely pre-assembled. File format: STL, OBJ, AMF, 3MF, FPP, BMP, PNG, JPG, JPEG.I myself have worked a lot and without problems with ERYONE PLA on this printer. It is therefore advisable to buy more filament if you should buy this printer.
The included filament is only enough for a few test prints. on the timing belts) are marked with small flags so that you cannot miss them.Įverything is included to start directly with your first test prints: Those cable ties that are not directly visible (e.g. Thus, all moving components are immovable and cannot be damaged during transport. the print head and the axes, are secured with thick cable ties. This is much more environmentally friendly than styrofoam and is also easy to recycle.Īll moving parts of the 3D printer, e.g. Unlike most other 3D printers, the inside of the package is not made with styrofoam or foam, but with molded cardboard. While the Voxelab Aries is very sturdy in itself, it is also very well secured from transport damage. The Aries is also well suited for advanced users because of its high reliability and high-quality workmanship.įor tinkering, this 3D printer is rather less suitable, since it is already a well-thought-out printer.